118 OBD
HEIGHT SIMULATION
Press 4 to select <HEIGHT SIM. TEST> from the <AIR SUSPENSION> menu. The
first line allows you to select which wheel is to be tested and the direction the car body
will travel for the test. The next four lines are status lines which show the height data and
valve positions for each wheel. A timer indicates how long the test has run for the
highlighted wheel. The status of the compressor motor and the exhaust valve solenoid are
displayed below the wheel data. Press y to start the test. Press n to terminate the
test.
ACTIVE KEYS
u d Select wheel position. Status line of wheel to be tested is highlighted. If the
up arrow is highlighted, select the direction of test (up or down).
l r Select wheel position or direction.
y Confirm that you wish to start the Air Suspension Height Simulation test.
n Stop test from being conducted.
x Return to the <AIR SUSPENSION MENU>.
NOTE
Do not drive the vehicle while the Height Simulation test is
being performed.
Comments to this Manuals