244 OBD II
2.0 FUNCTION SELECTION
When the Tester is powered up with the Program Card installed, you must confirm and/or
enter information about the program card.
POWER-UP
The program card identification screen is displayed when the Tester is powered up. Press
e to continue.
ACTIVE KEY
e Proceed to the <FUNCTION SELECT> Menu.
SELECTING A FUNCTION
All functions present in the Program Card are displayed. Refer to the following sections
for operating instructions:
<1: OBD/MOBD> OBD Operator’s Manual
<2: ENHANCED OBD II> See Section 3.0 Enhanced OBD II on page 245.
<3. CARB OBD II> See Section 4.0 CARB OBD II on page 275.
<4: BREAK-OUT BOX> Break-out Box Operator’s Manual
<5: NVH> NVH Operator’s Manual
<6: AUTOPROBE> OBD Operator’s Manual, Autoprobe section
<7: O2 RPM CHECK> OBD Operator’s Manual, O2S/RPM Check section
<8: SNAPSHOT REVIEW> OBD Operator’s Manual, Snapshot Review section
<9: SETUP> Tester Operator’s Manual, Using the Setup Mode section
<0: GAS ANALYSIS> Gas Analyzer Operator’s Manual, (USA only).
ACTIVE KEYS
u d Change highlighted menu item.
1 - 0 Select menu item.
e Select highlighted menu item.
x Return to the Power-up screen.
Comments to this Manuals