SEKURE SX-3100LCD Operator's Manual download pdf (Page 62)

50 TESTER

5.0 FINISHING UP

After using the Tester, a few simple steps will help you leave the vehicle electronics in the

proper state and also ensure that you get the most use out of your diagnostic tools:

1. Reconnect hoses, connectors, spark plug wires, fuel lines, etc. that were disconnected

from the vehicle during testing.

2. Before turning the Tester off, clear any Diagnostic Trouble Codes that may have been

set during the course of troubleshooting the vehicle electronics.

3. Remove power to the Tester by unplugging the DC power cable.

4. Disconnect the tester’s connecting cables from the vehicle.

5. Turn the Tester off by pressing px.

6. The program card may be stored in the Tester, or removed and stored in the program

card slot in the storage case.

7. Inspect the cables, connectors, and cigarette lighter for damage and corrosion.

8. Store the Tester, cables, and adapters in the storage case.

CLEANING AND STORING YOUR TESTER

Always clean the Tester screen by wiping vertically only. Never use a circular motion on

clear plastics.

HINT

If the Tester is turned on without a program card installed, or

with a different program card installed, the data stored in the

Tester memory, such as Snapshot data, will be lost.

NOTE

If the Tester, probe, or cables become dirty, they may be

cleaned by wiping them with a rag lightly coated with a mild

detergent or non abrasive hand soap. Do not immerse the

Tester, Autoprobe, or cables in water. Avoid using harsh

solvents such as petroleum based cleaning agents, Acetone,

Benzene, Trichloroethylene, etc. Although the Tester and

Autoprobe are water resistant, they are not waterproof;

thoroughly dry them prior to storage.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 377 378

No comments

SEKURE SX-3100LCD Operator's Manual Page 62